Quality Policy Environmental Policy Health & Safety Policy

GUIDED AUGER BORING

man in hole
 Horizontal guided auger boring is fast gaining a reputation as being a cost effective way of accurately installing small to medium diameter gravity sewers or steel ducts by means of trenchless technology. In reality, guided auger boring is indeed going some way towards filling the gap between conventional auger boring, where close tolerances may not be that much of an issue and in appropriate conditions, guided auger boring can match many of the benefits of micro-tunnelling.

This well-established system is very well developed and is capable of installing pipes to precise vertical and horizontal alignments.

The system is used in conjunction with a specially designed theodolite guided system, which provides extremely accurate pipe installation well capable of installing 100 - 600mm diameter pipes to extreme tolerances. Accurate pipeline installation is achieved through video monitor surveillance of an illuminated target through a theodolite; the steering of the pilot tube is accomplished by aligning an angled steering head to the desired course and thrusting forward. The rotation of the angled steering head allows the operator to keep the pilot tube on the planed line and grade.

The pilot tubes are installed sequentially behind the steering head. After the head has reached the reception shaft a reaming or cutter head and auger tube sections are installed behind these pilot tubes. With addition of each section of auger and tube in the launch shaft, a section of pilot tube is removed in the reception shaft. The process is repeated until all pilot sections have been removed.
A pipe adapter is then fitted to the last section of auger casing in the launch pit and the product pipe is jacked in while auger tubes are removed from the reception shaft.

Video monitoring of the illuminated target ensures that the precise tolerances needed for the gravity pipeline market are met. The theodolite, with its vertical lift and side-shift base, has a designed accuracy
of +/- 5mm up to 100m distance.
Drive Pit - Introduction of the Auger
hole
Drive Pit - Installation of a pilot tube
hole and pipe
Reception Pit - Arrival of the pilot tube